Mappings

You can use the Steeltoe mappings endpoint to return the MVC and WebAPI routes and route templates that are used by the application.

Configure Settings

The following table describes the settings that you can apply to the endpoint:

Key	Description	Default
Id	The ID of the mappings endpoint.	mappings
Enabled	Whether to enable the mappings management endpoint.	true

Each setting above must be prefixed with Management:Endpoints:Mappings.

Enable HTTP Access

The default path to the mappings endpoint is computed by combining the global Path prefix setting together with the Id setting described in the preceding section. The default path is /actuator/mappings.

See the HTTP Access section to see the overall steps required to enable HTTP access to endpoints in an ASP.NET Core application.

To add the actuator to the service container and map its route, use the hostBuilder.AddMappingsActuator extension method from ManagementHostBuilderExtensions.

Alternatively, first, add the mappings actuator to the service container, use the AddMappingsActuator() extension method from EndpointServiceCollectionExtensions.

Then add the mappings actuator middleware to the ASP.NET Core pipeline, using the Map<MappingsEndpoint>() extension method from ActuatorRouteBuilderExtensions.